各位大大小弟是linux 的菜鸟，有不好的地方请跟我说一下
我已经有爬过文了 但还是有诸多不了解
我想请问一下

今天我有
sata2 的250G 4颗
一张raid 卡
我的raid 卡已经做了raid5
那我再装linux 还需要做raid 0 吗
因为我装centOS 4.4跟redhat9.0 都会抓到4颗 hde hdf hdg hdi
所以我想说再做software raid 0 把她变一颗 因为raid 卡已经做raid 5
我也知道/ 跟/boot 都在hde1
GRUB 也装在MBR /dev/hde上
而且安装过程我都用预设 一路安装完后reboot
只会出现 ((GRUB _ ))
然后就没下文了
这是怎么一回事阿~~
请各位大大指导一下

You already made a raid 5 in your hardware raid card.
Then you don't need to make a soft raid in system level.
According to your messages, however, your raid card is not set properly.
The OS should only see a single 750GB harddisk instead of 4 x 250GB hdd.
e.g.
Total available size = 250GB x (N - 1) = 750GB

If your raid card cannot be detected while installing, you will need to provide a linux driver for it.

楼主的安装步骤出问题了，建议你去参考一下正确的安装步骤或是自己多试几次，我就是自己多事了计财最后才成功的